Air fuel Ratio Gauge.

[Patchman]

What is a good complete kit for a turbo/ carbureted project. I don't have any other electronics to tie into so it has to be a stand alone kit. Anyone have any experience one way or another? think.gif

 

[73 Sanger Flat]

My Brother in law just bought the Fast # 170402  , He has not had the chanec to test it on the boat yet , we will need to weld the bung  in the header or someway to get the reading from the exhaust .. He also opted for the rpm module ..

He came up with a sketch to add a pipe inside the header so he does not weld to his new coated headers ..

 

[Patchman]

I saw that post, I think his idea will work fine. I'm looking for a permanent guage set up for a car. Something that will give me an idea at where I'm at under boost conditions in a guage configuration. No data logging here just simple setup.

 

[73 Sanger Flat]

I was looking in Jegs and Summit and seen the o2 gauges to mount in the dash and the 02 sensor and cord . I tought about going that route until Galen bought his and I can borrow his..

 

[73 Sanger Flat]

This was kinda what I was looking at ..

http://www.jegs.com/i/Innovate+Motorsports/540/3781/10002/-1


and summit
http://www.summitracing.com/parts/ATM-4370/

 

[Patchman]

Those are both what I have been looking at. Just wondering if anyone has any experience with them. think.gif

 

[galen]

Patch go to  http://www.aemonly.com    I know a couple people are using these and they are priced under 200$.  AEM UEGO wideband kit. You can also get them off ebay.  Do a search and see how people like them.  Galen

 

[Patchman]

Thanks! I saw those in Summit, actually put it on my parts list. :smile30: