73 Sanger Flat
Active member
I going to sell my Merlin 2 Tall Deck Block this winter .Fresh Bore is 4.560 ,Maybe 3 hours run time on it . The block can be bored to 4.620.. With a 4.25 crank and this bore , it is a 555 cubic inch .
The block is filled half way ( bottom of water pump holes ) with block fill or concrete .
This would make some one a real good engine for a race boat or car.. Could not use on the street ..
The Merlin 2 block sells for over 2000.00 , I will take 800.00 for it .. This is just the bare block , it will have cam bearings , They are almost new . maybe 3 hours run time on them . No rotating assemble unless you want to pay for them .. It has a 4.25 stroke Callie Compstar Crank , Scat 6.8 Rods and 13.6 to 1 J. E. pistons and a Howard custon Grind cam , lift is 765 . 268 & 274 Duration ..
I will be replacing the block this winter , so if any one is interested , let me know ..
Thanks
Billy
The block is filled half way ( bottom of water pump holes ) with block fill or concrete .
This would make some one a real good engine for a race boat or car.. Could not use on the street ..
The Merlin 2 block sells for over 2000.00 , I will take 800.00 for it .. This is just the bare block , it will have cam bearings , They are almost new . maybe 3 hours run time on them . No rotating assemble unless you want to pay for them .. It has a 4.25 stroke Callie Compstar Crank , Scat 6.8 Rods and 13.6 to 1 J. E. pistons and a Howard custon Grind cam , lift is 765 . 268 & 274 Duration ..
I will be replacing the block this winter , so if any one is interested , let me know ..
Thanks
Billy