The South is sure quiet!

Devilman

Devilman

Well-known member
ChryslerJet said:
Lurkin Around?? Trollin??  Anything good out there?
Click to expand...

Researchin I guess you'd say. Was taking a look around the shop yesterday & realizing I got some stuff I could unload... bring in a little extra $$$ & clear out some stuff, quit moving it from place to place, lol..
 
C

ChryslerJet

New member
Devilman said:
ChryslerJet said:
Lurkin Around?? Trollin??  Anything good out there?
Click to expand...

Researchin I guess you'd say. Was taking a look around the shop yesterday & realizing I got some stuff I could unload... bring in a little extra $$$ & clear out some stuff, quit moving it from place to place, lol..
Click to expand...
LOL what kinda stuff? Boat stuff? Car stuff? or junk stuff?
 
Devilman

Devilman

Well-known member
ChryslerJet said:
LOL what kinda stuff? Boat stuff? Car stuff? or junk stuff?
Click to expand...

Don't really have much boat stuff... car/truck stuff mostly: some alum. wheels, some old school offroad lights, r/c car stuff.... thats just off the top of my head. I'm sure there is more if I look around or think about it more.
 
C

ChryslerJet

New member
That makes me think I need to get a set of 14" rims for the trailer.  Its got 15's on it now but I want to lower it a bit and removing the single axle and putting on dual torsion axles.  I think the 14's will drop that trailer so I can launch in almost any ramp.  Got any 14" Aluminum Trailer rims 5x4.5?  I have been thinking of going with a set of Mopar ralleye wheels since it is a Mopar.  Oops am I thread jacking again?
 
Devilman

Devilman

Well-known member
Mopar rallye wheels would look good on there. and different too. Only 14s I have is a pair of slot mags, don't recall how wide. Only have two though.
 
C

ChryslerJet

New member
Well cant work outside on the boat or chopper.  No garage to work in. No other indoor projects.  At work bored guess I am here then. jump.gif
 
Patchman

Patchman

Administrator
Staff member
ChryslerJet said:
Well cant work outside on the boat or chopper.  No garage to work in. No other indoor projects.  At work bored guess I am here then. jump.gif
Click to expand...
What do you do, for a livin? think.gif
 
C

ChryslerJet

New member
Right now its in Pieces while I fab a new single down tube and get the new neck on straight and at the right rake.  At least I finished the extensions on the forks already.  Good thing I made them 2" longer than I thought I needed cause the new rake is going to use every bit of it.  I will put up some pics later of the before shots not sure I have any from when I first got it.  Also need to put in the new stator and water pump for the motor.  Lots to do.  Goal is to finish up the welding this week and get the motor running and installed with the new fabbed motor mounts and brackets.  That way I can at least test drive her then need to finish the wiring and lights and mount the seat. Then fab up an air dam and side covers from aluminum tread plate.  Oh and cant forget mounting the sissybar.
 
You must log in or register to reply here.
Top